When Mig Welding Push or Pull – The Ultimate Guide to Push or Pull Welding
Welding is an important skill to have, whether you work in a shop or are a DIY enthusiast. But knowing when to use the right welding technique, such as whether you should push or pull when welding, can be tricky. With the right knowledge, though, you can get the job done right.
In this guide, we’ll explain the basics of push or pull when welding, as well as when to use each technique. By the end of this article, you’ll know the answer to the question “when mig welding push or pull?” and when to use the push or pull technique for tig welding.
What is Push or Pull Welding?
Push or pull welding is a welding technique where you move the torch in either a push or pull motion. This technique is used for both tig and mig welding.
When you’re mig welding, you’ll be using a wire feeder to feed the wire into the weld joint. When you’re tig welding, you’ll be using a tungsten electrode to create the arc.
The push or pull technique is used to control the weld puddle and create a good quality weld. Depending on the type of weld you’re doing, you’ll want to use either a push or pull motion.
When to Use Push or Pull Welding
When you’re mig welding, you’ll usually want to use a push motion. This is because a push motion helps to keep the weld puddle in the joint, making it easier to create a good weld.
When you’re tig welding, you’ll usually want to use a pull motion. This is because a pull motion helps to keep the tungsten electrode away from the weld puddle, which helps to keep it from overheating and breaking.
Push or Pull When Tig Welding
When tig welding, it’s important to use the right pushing or pulling technique. As mentioned above, you’ll usually want to use a pull motion when tig welding.
When you’re using a pull motion, you’ll want to move the tungsten electrode away from the weld puddle. This helps to keep the electrode from overheating and breaking.
When you’re using a push motion, you’ll want to move the tungsten electrode towards the weld puddle. This helps to keep the weld puddle in the joint, making it easier to create a good weld.
Push or Pull When Mig Welding
When mig welding, you’ll usually want to use a push motion. This is because a push motion helps to keep the weld puddle in the joint, making it easier to create a good weld.
When you’re using a push motion, you’ll want to move the wire feeder towards the weld puddle. This helps to keep the wire feeder away from the weld puddle, which helps to keep it from overheating and breaking.
Conclusion
Now you know the answer to the question “when mig welding push or pull?”. When tig welding, you’ll usually want to use a pull motion, while when mig welding, you’ll usually want to use a push motion.
By using the right pushing or pulling technique, you’ll be able to get the best results from your welds. With the right knowledge and practice, you’ll be able to create strong, high-quality welds for any project.
Leave a Reply